2.1 MAINS ELECTRICAL CONNECTIONS
 
The vending machine is delivered with a mains cable for connection to a 230 Volts 50 Hertz single phase supply.
 
In connecting the machine to an electrical supply observe local regulations and by- laws.
The vending machine must be earthed and a check for earth continuity must be made. We advise the fitting of an RCD UNDER NO CIRCUMSTANCES should the electrical connections in the machine be modified
 
 
 All technical operations must be carried out by qualified personnel.
 
 
The electrical power requirements are stated on the name plate and any plugs must be wired to conform to prevailing legislation
 
CABLE IDENTIFICATION
                                           GREEN/YELLOW     EARTH
                                            BLUE                       NEUTRAL/RETURN
                                            BROWN                  LIVE/ACTIVE
 
 
 
    THIS APPLIANCE MUST BE EARTHED. CHECK FOR EARTH CONTINUITY
 
 
2.2 Installing payment systems
 
·    Vending machines are normally supplied without a payment system unless ordered specially. The installation of payment systems is normally the responsibility of the client.
 
Coin mechanism
The fixings for the coin mechanism are located inside the front door cover plate. It is important that the motor reject arm hits the eject button on the coin mechanism properly to allow any rejected coins to be returned to the user. The reject striker arm can be adjusted so that when the motor rotates, it completely depresses the reject arm. This can be done by adjusting the two screws on the reject striker.
 
Once the coin mechanism is located and the reject lever is operating correctly, with the power switched off; the leads from the coin mechanism should be plugged into the leads coming from the micro processor board. It is important that the leads do not foul the coin chute or any other parts of the mechanism inside.
 
Electronic payment Key reader
A key reader can be installed directly below the key board and the appropriate hole can be cut out from the front panel.
  
Banknote reader
A Banknote reader can be inserted directly above the key panel. It is important that the note stacker does not get in the way of product spirals on the top right hand part of the machine. Make sure that products can drop properly once the note reader has been fitted.
  
2.3 DISPLAY
 
 
Manea Models MSX10-MSX8 are fitted with a graphic display of 128x128 characters protected by a Lexan screen. The LCD display enables the user to make selections and for the operator to program and retrieve data from the machine.
 
To clean the protective Lexan front, use a damp cloth, the display can be removed and cleaned from behind.
The contrast level of the LCD screen can be adjusted using the trimmer on the microprocessor board.
 
         
Adjustment of the LCD screen must be carried out by an authorised technician.