The errors menu allows the operator to see the last 10 error codes recognised by the machine, even

if they are subsequently rectified/verified.

 

The following codes displayed on the left hand part of the display are preceded by the letter E.

 

Some errors do not stop the operation of the vending machine but they signal possible malfunctions. Other errors will disable the machine completely

The errors which are displayed are those recorded since the programming menu was last activated

 

  10.2 ERRORS CODE

  

Cod. 0 Machine functions OK

Cod. 1 Error in the program. Replace of the firmware

Cod. 2 Software error

Cod. 3 Error on elevator

Cod. 4 Software error

Cod. 5 Error of spiral. N/O contact of the Microswitch not making

Cod. 6 Principal spiral error. Time out first impulse

Cod: 7 Principal spiral error. I not contact micro connected

Cod. 8 Principal spiral error. Time out according to impulse

Cod. 9 Error programs

Cod. 10 Spiral error secondary. Motor not ok

Cod. 11 Spiral error secondary. Time out first impulse

Cod. 12 Spiral error secondary. Contact of N/O of the Microswitch not connected

Cod. 13 Spiral error secondary. Timed out according to impulse

Cod. 14 Error programs

Cod. 15 Error elevator. Faulty encoder or disconnected

Cod. 16 Error CAN Bus. Block

Cod. 17 Attention. Reset files I/O

Cod. 18 Card incompatible I/O-problem of communication

Cod. 19 Setting of elevator not correct

Cod. 20 Refrigeration unit timed out (Has been on too long)

Cod. 21 Temperature of alarm reached

Cod. 22 Lost communications with payment system

Cod. 23 Vend detect not made or faulty, defective, misaligned vend detector